House drainage plan – A badly drained yard around your house can cause a series of problems. For example, water sitting on the foundations of your home can lead to leaks, while standing water in other areas of your property can make it impossible to plant in your garden. Eliminate water problems in different areas of your property by installing drainage around your house. Check and correct the inclination around the house. Place a pole approximately 10 feet long on the ground so that it points straight out from the base with a right end that sits against the back of the house. Establishment of a level at the top of the pole or board.
Lift the end of the stick or the joint that is not against the base until the level bubble is in the center. Once the pole or board rests level, measure the distance between the bottom edge of the post or board and the ground. Increase the slope around the foundations of a house by adding padding soil against the base if the distance between the pole or board and the floor is less than 6 inches. Continue adding dirt to the base until you get a 6-inch measurement.
24 Photos Gallery of: House Drainage Plan To Install
Create a drainage ditch at any point around a home where the water pools or bleachers. Start the first end of the trench just below the problem point and aim the trench down any natural slope on your property. Dig the trench to a depth of approximately 18 inches and a width of 6 inches. Lay the garden fabric in each trench so that it lines the inside of the trench completely and put 1-inch gravel to each trench approximately 6 inches below ground level. Wrap the excess gardening fabric that lines the trench on top around the top of the gravel.
Cover the gravel fabric and landscaping with builder’s sand until it sits level with each trench. If you want to hide the ditches from view, put grass on the sand in each ditch. If you want to keep the ditches visible, place a layer of 1-inch gravel over each ditch to cover the sand. If you do not have the proper slope on your property for your drainage channels, dig the slope while digging the trench. You can accomplish this by digging the first end of the trench below the trouble point to a depth of only 12 inches and gradually increasing the depth of 18 inches at the opposite end.